Port Forwarding

    • Level   X

    Technicolor-TC8305C


    Login Info:

    Gateway-10.0.0.1

    Username-admin

    Password-password


    Port Forwarding

    1. Open a web browser.
    2. Log into the router by entering the default gateway into the address bar of the internet browser. (Example 10.0.0.1)
    3. The gateway will then prompt for a user name and password.  The default user name is “admin” and the password is “password”.
    4. From the menu on the left select Advanced.
    5. From the submenu on the left select Port Forwarding.
    6. Select Enabled next to “Enable Port Forwarding”.
    7. Select “+ Add Port Forward”.
    8. In the following screen enter a Service Name. This should indicate Xbox Live (example: XBL or xbox360).
    9. Change the Service Type to TCP/UDP.
    10. Enter the IP Address assigned to the Xbox console in Server IP Address.
    11. For Start Public Port, End Public Port and Private Port(s) enter 3074.
    12. Select Save.

    Disable Port Forwarding

    1. Open a web browser.
    2. Log into the router by entering the default gateway into the address bar of the internet browser. (Example 10.0.0.1)
    3. The gateway will then prompt for a user name and password.  The default is that user name is “admin” and the password is “password”.
    4. From the menu on the left select Advanced.
    5. From the submenu on the left select Port Forwarding.
    6. Select Disable or select the “X” on the ports you would like to remove.

     

    ϟ ϟ

    • Level   1

    What About Technicolour:TC7200.U

    • Level   2

    The default gateway for TC7200-U f is 192.168.0.1 and the default username and password are both 'admin'.  The remaining steps are very similar to the one above.  Click Advanced, click Forwarding, click Add row, and then add a row for each of: 53, 80, 88, 500, 3074, 3544 and 4500.  Set the Public Port Range and Target Port Range to the same for each of these.  For example for port 53 the Public Port Range is 53-53 and the Target Port Range is 53-53.  Target IP Address is blank and Protocol set to Both.  Continue to add rows until you have each port added in a similar fashion then click Save.  That's it!

    Did you find my post helpful?  Be sure to hit "Like" if so!